DeLonghi Domino Especificaciones descargar pdf (Pagina 13)

Figure 13 Figure 14

MINIMUM BURNER SETTING ADJUSTMENT

Check whether the flame spreads to all burner ports when the burner is lit with

the gas tap set to the minimum position. If some ports do not light, increase the

minimum gas rate setting.

Check whether the burner remains lit even when the gas tap is turned quickly

from the maximum to the minimum position. If the burner does not remain lit,

increase the minimum gas rate setting.

The procedure for adjusting the minimum gas rate setting is described below.

For taps with adjusting screw inside the shaft (fig. 13):

✓ using a screwdriver max. diameter 3 mm turn the screw inside the tap shaft until

the flame setting is correct.

For taps with adjusting screw on the body (fig. 14):

✓ using a screwdriver turn screw "A" until the flame setting is correct.

Normally for Propane gas, fully tighten the adjustment screw.

LUBRICATING THE GAS TAP

If a gas tap is difficult to turn, disassemble it, clean it carefully with petrol and spread

a little high-temperature-resistant grease on it.

These operations must be performed by an Authorized person/Service agent.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

DeLonghi Domino Especificaciones Pagina 13